INTRODUCTION
SMR2003_001_00_00A2.FM XIII
Mounting in Tandem
1. Apply retaining compound on internal element
bore.
2. Continue to assemble as shown above.
CASE-IN COMPONENTS
Metallic Gaskets
1. Proper strength Loctite
1. Clean inner housing diameter and outer gasket
diameter.
2. Spray housing and gasket with Loctite Primer N
(P/N 293 800 041).
3. Apply a strip of proper strength Loctite on lead-
ing edge of outer metallic gasket diameter.
NOTE: Any Loctite product can be used here. A
low strength liquid is recommended as normal
strength and gap are required.
4. Install according to standard procedure.
5. Wipe off surplus.
6. Allow it to cure for 30 minutes.
NOTE: Normally used on worn-out housings to
prevent leaking or sliding.
It is generally not necessary to remove gasket
compound applied on outer gasket diameter.
TIGHTENING TORQUES
Tighten fasteners to torque mentioned in explod-
ed views and text. When they are not specified
refer to following table.The table also gives the
metric conversion.
A00A3VA
1
N•m FASTENER SIZE (8.8) Lbf•in
19
2M418
327
4M535
544
653
762
871
980
10 M6 89
11 97
12 106
13 115
14 124
15 133
16 142
17 150
18 159
19 168
N•m FASTENER SIZE (8.8) Lbf•ft
20 15
21 15
22 16
23 M8 17
24 18
25 18
26 19
27 20
28 21
29 21
30 22
31 23
32 24
33 24
34 25
35 26
36 27
37 27
Commentaires sur ces manuels